Instructions for General Use:

1. Following washing the vehicle and while it is still wet, add 2-3 fl oz of Adam’s Rinse Aid to Foam Cannon/Gun Reservoir and dilute to volume with fresh water.
2. Spray or hose Adam’s Rinse Aid solution over entire vehicle including paint, glass, wheels and plastics – this solution can be applied to all exterior surfaces safely and effectively. However, do not let the solution dry on the surface or residues could manifest.
3. Once all surfaces are sufficiently coated, disconnect Foam Cannon/Gun and switch to fresh water and rinse all excess material off the surface thoroughly or proceed immediately into drying.
4. Either towel dry or use forced air to finish drying the vehicle completely.

Quick Detailer / Drying Aid:

1. Adam’s Rinse Aid can also be diluted to make an effective quick detailer and/or drying aid solution by diluting the concentrate with fresh water at 1:9 (1 part concentrate with 9 parts water for a total of 10 parts).
2. Following washing the vehicle and while it is still wet, mist the Quick Detailer solution onto all exterior surfaces working a few panels at a time.
3. Using pressurized water, spray off the excess solution thoroughly and note the instantaneous hydrophobic behavior on the surface.
4. Either towel dry or use forced air to finish drying the vehicle completely.

Common Sense Warning:

Adam’s Rinse Aid is a concentrated solution and requires dilution prior to use. It is designed to be used in conjunction with a foam cannon and a pressure washer or a foam gun and a garden hose, unless diluted using the Quick Detailer / Drying Aid instructions.